Hi.
I know this post is very old, but I begin to Lost my mind and I think you are my last chance.
I bought long time ago a Duo Whitout caps and with caps new to install.
Board was really bad, a lot of pads missing, no volume control, no switch of CD cover open and close...
With a lot of time and patience I have get to star system card 3, repair volume and start games en hucards.
My final problema is CDs doesn't spin...I have try to configure all pots and I have revised all caps several times but always the same result:
-lens comes to the center
-lens go up and down 3 or 4 times.
-message of "revise CD"...
CD never spin.
I am desperate, long time spends and I begin to think I cant repair...
Someone can give some advice?
If I watch lens, I can see the red light of laser without CD.
Motor works, if I connect 3V to the motor, motor spins.
Thanks a lot.
I know this post is very old, but I begin to Lost my mind and I think you are my last chance.
I bought long time ago a Duo Whitout caps and with caps new to install.
Board was really bad, a lot of pads missing, no volume control, no switch of CD cover open and close...
With a lot of time and patience I have get to star system card 3, repair volume and start games en hucards.
My final problema is CDs doesn't spin...I have try to configure all pots and I have revised all caps several times but always the same result:
-lens comes to the center
-lens go up and down 3 or 4 times.
-message of "revise CD"...
CD never spin.
I am desperate, long time spends and I begin to think I cant repair...
Someone can give some advice?
If I watch lens, I can see the red light of laser without CD.
Motor works, if I connect 3V to the motor, motor spins.
Thanks a lot.