Thanks for your answer, i go to check all the vias if i see something.
Thanks again!
Thanks again!
 |
The Analogue Turbo Duo clone shipped in time for Christmas 2023. Are you happy with yours ?? Find firmware updates here.  |
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Console Repair/Mod Center / Re: Turbo Duo CD-Rom issue
11/19/2024, 10:30 AM
Quote from: NightWolve on 11/09/2024, 10:50 PMYou want a photo of the area? Do you not know what a via looks like?? It's a drilled hole to divert a trace from one side to the other, top to bottom. If it's corroded you can shine it up with sand paper, both sides, add flux and then apply solder both sides! That should restore full conductivity/continuity. Once finished, check continuity with a DMM that you get 0 to low Ohms.
Thanks for your answer.
I found the via and solved it, but now, the laser go down when i power on the pce. But the disc not spin, and when i hit run button, doesnt do nothing. Change the message to please wait and nothing, doesnt spin, and doesnt read nothing.
Any ideas?
Regards
#3
Console Repair/Mod Center / Re: Turbo Duo CD-Rom issue
11/08/2024, 10:17 AM
Quote from: thesteve on 09/09/2018, 02:41 AMwhat KC said was correct
there are 2 huge traces that run across the front of the unit sending 5V to the CD system
the VIA near the 47uf caps by the LED gets eaten away and you lose 5V to the chips causing this issue
Hi,
Can you show me, whats is this via? Because i have the same problem. 2,4v in the first 2 pins of the spinner.
Pages1