Messages

[Console Repair/Mod Center / Re: Building my own PCE stick - help needed]

Well, I googled it before asking here but wasn't happy with the results I've gotten because I'm not all that technical. Hence my asking on this board. But thanks for that particular insightful advice.

As I understand it I should look at the chip instead of the connectionpoint (don't know if it's the right word) on the pad?

Will give it another look once I open up the pad tomorrow, thanks for the advice so far!

[Console Repair/Mod Center / Building my own PCE stick - help needed]

Hi all,

Been lurking around here for a while, ever since I decided tot buy a pce duo-r, living the daylights out of it ever since, best decision I made this year

Anyway, I was thinking of building my own stick, mainly tot be used for shooters, so I've been reading up on that and preparing this little project. There is a ton of info out there on how to do this, but not on one subject: turbofire.

Do I keep the switches or is it possible to solder them like you would the other buttons? Or am I doing it all wrong?

I'm going to hack a cheap 3rd party pce pad, so there might be a difference in the PCB compared to an original controller, nut is there anybody that can point me in the right direction as how to proceed with this?

Pardon my mistakes, not a native speaker and auto correct is driving me insane atm :p