turbografx controller to pce mod

[kakutolives]

so I recently got a mini din 8 pin socket. I want to solder the turbografx controller wires and install them to the mini din socket, so it works on a pce instead.
anybody tried this and if so anybody got a color guide which could tell me which color goes to which pin?

thanks.

[Duo_R]

it's not too hard, check pinout on Gamesx.com and use an ohmmeter, you can figure out the existing wiring and then how you will adapte to PCE.

[henrycsc]

A better solution might be to swap the cables of a Turbo Tap and a PCE Tap.  That way you have an extension and a converter that you can then use all your original controllers on the other system.

I'm sure there's a thread on how to do it.

[GohanX]

I've done that in reverse to use PCE controllers on a TG16, it's very nice.

Kakuto, an easier way of doing this is get a junk PCE pad and just swap the cables. The little wiring harness plugs right into the controller, no soldering required.